Specifications:
Item: PPM Encoder
Color: Black
Size: 28 x 19 x 5mm
Supports Input Channels: 8
Cable Type: 10 Pin and 4 Pin
10 Pin Input Cable: 60mm
4 Pin Output Cable: 100m
Net Weight: 8g (Include All Wire)
Package Size: 12 x 8 x 0.7cm
Compatible With: For Pixhawk/ PPZ/ MK/ MWC Flight Controller
Suit for: Any R/C Receiver
Feature:
The PPM Encoder plugs into the PWM servo output ports of any R/C receiver and encodes them into a PPM pulse suitable for many autopilots (e.g. Pixhawk). Modifications to the R/C receiver are not necessary.
The whole project is based around the ATMEL ATMEGA328p AVR processor and all timing is done within interrupts so accuracy and stability is optimized.
The design of the PPM Encoder is based on the Paperazzi PPM Encoder.
Important Note:
The firmware comes pre-configured to read 8 Channels. In case you would like to change the settings of the PPM encoder to invert the PPM signal and change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it.
The jumper on the board no soldering default. In this case the board powered by FC.
Note: Due to the difference between different monitors, the picture may not reflect the actual color of the item. We guarantee the style is the same as shown in the pictures. Thank you!
Package Content:
1 x PPM Encoder
1 x 10 Pin Input Cable
1 x 4 Pin Output Cable
