Kortinnstilling Arduino IDE: DOIT ESP32 DevKit v1.0
Kan være nødvendig å sette Flash Frequency til 40MHz.
Husk å trykke programmeringsnappen under opplastingen av programskissen.
COM-port driver: CP2102 (Kan ha den del driverutfordinger)
Introduction:
ESP32 is already integrated antenna and RF balun, power amplifier, low-noise amplifiers, filters,
and power management module. The entire solution takes up the least amount of printed circuit board area.
This board is used with 2.4 GHz dual-mode Wi-Fi and Bluetooth chips by TSMC 40nm low power technology,
power and RF properties best, which is safe, reliable, and scalable to a variety of applications.
Features:
High performance-price ratio
Small volume, easily embeded to other products
Strong function with support LWIP protocol, Freertos
Supporting three modes: AP, STA, and AP+STA
Supporting Lua program, easily to develop
Package included:
1 x ESP32 Development Board
Konfigurasjon av Arduino IDE:
Intern blinkende diode: LED_BUILTIN (lik 2 for denne enheten)
Boot-tasten må trykkes for at programskissen skal kunne lastes opp.